Open DIY Projects › Stuhlkreis › talking english… › EagleEi Runcam 2 gimbal › Antwort auf: EagleEi Runcam 2 gimbal
22. November 2016 um 9:13 Uhr
#3517
gyrex
Teilnehmer
Thanks for your response Benny! 🙂 I think I’ll share a GND between the 2 motors so I can run a 5V supply to the camera.
I got a separate IMU with my Storm32 board and I’ve installed it into the camera base.
I’m sorry about all these questions but it’s hard to find a step by step guide and I’m a hobby newbie 🙂 I have a question about the walkera motors. The spindle sticks out and doesn’t allow a flush fit on the horizontal section and it sticks out on the side.
Do I need to cut this motor spindle down so it fits?
Thanks for your help Benny.