Open DIY Projects Stuhlkreis talking english… EagleEi Runcam 2 gimbal Antwort auf: EagleEi Runcam 2 gimbal

#3543
gyrex
Teilnehmer

Hi Benny,

I’ve been busy building my new quad but now I’m back to building the gimbal 🙂

I’ve got a few questions…

I followed the build instructions from this video https://www.youtube.com/watch?v=0oEWqlcZsoU. My question is relating specifically to this section:

I’ve oriented my build of this section exactly as it appears here with 1. the indent facing to the right 2. The larger opening facing the inside on the left and 3. the smaller opening facing the inside on the right.

Is this correct? My motor obviously won’t fit in the small opening on the right. I’ve taken a few photos of my build and was wondering if you could take a look and tell me if there’s a problem with how I’ve built my support.

Also, I’m worried about gluing the motor in. Can you offer some advice? I’m specifically worried about gluing the motor in and accidentally gluing the bearing you can see in the second photo below. I was planning on using 5 minute epoxy glue to glue these in, is this what you recommend?